These are very schematic directions to install GAMMA on a network with

-)	at least 2 PCs, each equipped with a GAMMA-supported network adapter
	(see GAMMA web page, http://www.disi.unige.it/project/gamma).

-)	a Gigabit Ethernet switch, connecting the PCs to one another.
	If you have only 2 PCs you may consider a back-to-back connection
	using a crossover cable.

-)	Linux 2.6.24, with source files installed on the PC where you
	are going to compile GAMMA.


1)  Get the latest gamma.tgz from the GAMMA web page,
    http://www.disi.unige.it/project/GAMMA.
    Place it somewhere in your file system (your home dir is OK).

2)  Unpack the source code with the following command:
    tar xvzf gamma.tgz
    A directory named "gamma" is then created, which contains all the stuff.

3)  Under gamma/docs you will find the GAMMA installation manual
    (installGAMMA.pdf).  Read it carefully while installing GAMMA.
    The manual is always worth a reading, although the installation procedure
    is quite simple in most cases ("configure && make && make install").

Giuseppe Ciaccio	15 April 2009		ciaccio@disi.unige.it